Replacing The Hard Drive In The Hard Drive Kit - Gateway Solo 1450 Service Manual

Replacing components in your Gateway Solo 1450
Replacing the hard drive in the
hard drive kit
Tools you need to complete this task:
Screws removed during this task:
2 black 2.5 × 5 mm
(hard drive)
To install a new hard drive into the kit:
1
Disconnect the power cord, remove the battery, and prepare your
notebook by following the instructions in "Preparing your notebook" on
page 5.
2
Remove the hard drive kit by following the instructions in "Replacing
the hard drive kit" on page 6.
8
Phillips #0 driver
4 chrome 3 × 3.5 mm
(hard drive)
www.gateway.com