Front Leds - Pace 921VNX User Manual

LED C
OLOUR
P
OWER OFF
AMBER
RED
GREEN
E
THERNET OFF
SOLID GREEN
FLASHING GREEN
W
IRELESS OFF
GREEN
WPS
OFF
SOLID GREEN
FLASHING GREEN
P 1
HONE OFF
SOLID GREEN
FLASHING GREEN
P 2
HONE OFF
SOLID GREEN
FLASHING GREEN
3G
OFF
S
OLID GREEN
B
ROADBAND OFF
S
OLID GREEN
FLASHING GREEN
I
NTERNET OFF
RED
S
OLID GREEN
FLASHING GREEN
D
ESCRIPTION
Power Off (Power supply not plugged or I/0 switch off on the rear panel)
Firmware update is on-going.
CPE boot failure. Failure due to internal sequence or state that will prevent the device from
connecting to the access network or passing customer data.
The device is powered on (power supplied and I/0 switched on the rear panel).
No Ethernet device connected on the LAN.
One Ethernet device connected and no traffic is passing through the CPE.
One Ethernet device connected and traffic is passing through the CPE (either direction).
Wi-Fi is disabled. (Option unchecked in the UI).
Wi-Fi is enabled (Option checked in the UI) which is the default behaviour. A wireless device
can be connected.
WPS is disabled. (Option is unchecked in the UI).
WPS is enabled (option is checked in the UI) which is the default behaviour.
WPS button is pushed on. Pairing process is on-going for 120 seconds. A wireless device can
be paired. After 120s the WPS Led becomes solid green.
No VoIP account set up.
or Registration to the softswitch failed.
The VoIP account number one is set up and registered to the softswitch.
Phone call is on-going.
No VoIP account set up.
or Registration to the softswitch failed.
The VoIP account number two is set up and registered to the softswitch.
Phone call is on-going.
No 3G USB key plugged in the CPE.
A 3G USB key is plugged in and detected by the CPE. The CPE has a 3G WAN IP address.
Broadband interface powered off, no signal detected.
Broadband physical connection is established (e.g. DSL sync).
Signal detected, in process of synchronizing.
Broadband physical interface connection not present.
Device attempted to become IP connected and failed (DHCP, PPPoE, PPPoA, etc.).
The CPE has a WAN IP address and there is no activity on the WAN.
The CPE has a WAIN IP address and there is activity on the WAN.
F LED
RONT
2 | P a g e
S