Welcome to the Telkom VPN Lite router setup user manual. This manual will provide information on how to setup the Telkom VPN Lite service on your Pace 921VNX using the setup utility, the router’s graphical user interface (GUI) and CLI (Telnet or Console connection) commands (advanced user only).
Below is an image to show you what information on the VPN- Lite setup site needs to be retrieved to enable you to setup you VPN-Lite. You can find this screen in the Manage Sites section.
VPN-Lite Setup using the Web Browser Wizard This section will guide you through the relative steps to setup you VPN-Lite service using the router’s built-in VPN-Lite Wizard in the web browser. Connection to the router using your web browser Open a web browser like Internet Explorer or Mozilla Firefox. In the internet address bar type in http://10.0.0.2 and press enter.
Page 6
Click on Enabled, to enable the VPN Lite functionality. By using the information retrieved from the Telkom VPN-Lite setup website (see page 4) enter your site username, site password and site LAN IP range using the IP slash notation as it appears on the Telkom VPN-Lite website.
VPN-Lite Manual Setup Using Telnet The following section will guide you to setup you VPN-Lite servise using the Telnet command line interface. Before you start please refer to the Before you start section in this document see page 4. 1. IP Management: a.
Page 8
IPAddress 10.0.17.2 set SubnetMask 255.255.255.0 cd _ fcommit Please see the correct LAN IP target range for your local site indicated on the VPN-Lite web page screen shot below. This will terminate Telnet session. TELKOM VPN-Lite 2.5 ver.100712 Page 8...
Page 9
LAN IP. Once you received the “ >” prompt, please continue with the next steps. Running the script: The script below sets up the VPN-Lite service on your Pace 921VNX. Please re-type or paste each of these commands into the telnet session that has been opened to the router in step 2a above (while substituting the <angle brackets>).
Page 10
Password <ISP account password> fcommit cd .. Comment: Add NATting for Internet Connection set NATEnable 1 cd PhysicalInterface_1 set Enable 1 set Type ATMEthernetInterface set Index 1 cd _ cd WANConnectionDevice_1_WANIPConnection set Enable 1 cd _ fcommit TELKOM VPN-Lite 2.5 ver.100712 Page 10...
Page 11
Enable 0 cd _ cd WANConnectionDevice_2 set Enable 1 cd _ fcommit Comment: Add static routes to private IP ranges facilitating communication with remote VPN-Lite sites: cd Layer3Forwarding_Forwarding mk 1001 set Enable 1 set Description VPN set User 1...
Page 12
DestIPAddress 192.168.0.0 set DestSubnetMask 255.255.0.0 cd _ fcommit Comment: Save configuration and restart device: fcommit reboot g. After your Pace 921VNX has rebooted, the VPN-Lite solution will be setup and ready for use. TELKOM VPN-Lite 2.5 ver.100712 Page 12...
You will be prompted to supply a username and password to logon to the router. User name = admin Password = admin. Firmware Upgrade In the menu on the left click on Management then select Upgrade. The following screen will appear on the right. TELKOM VPN-Lite 2.5 ver.100712 Page 13...
Page 14
A progress bar will give indication on the progress of the upgrade. Do not switch off the router or disconnect any cables at this stage. On completion of the upgrade you will be prompted to restart the router as shown below. TELKOM VPN-Lite 2.5 ver.100712 Page 14...