Linn MAJIK Service Manual page 21

Sept 95
8. Take the RCU module and separate the two parts carefully as
shown.
9.. Take the part of the RCU with the buttons.
10.. Place it face down over the facia
interim plate.
Check the operation of the
buttons.
11. Fit the other half of the RCU onto the assembly.
The re-assembly is the reverse of the strip, (step 2 & 1), except for the
connections.
Connect the RCU to the Sneaky module as follows:
Sneaky Receiver:
1. Connect 'Main' on RCU to 'Internal RCU OUT' on Sneaky module.
2. Connect 'Ext' on RCU to 'Internal RCU Return' on Sneaky module.
Sneaky Driver:
Connect 'MAIN' on RCU to 'Internal RCU Out' on Sneaky Receiver
Links:
Sneaky Receiver: Remove all 4 links at P5.
Sneaky Driver:
INSTALLING THE KNEKT RCU/S CONTROL PANEL
No links changes required.
Copyright © 1995 by Linn Products Limited. All Rights Reserved.
REVISION 14: MAJIK and WAKONDA
Take care that the ten-pin plug
and socket are aligned prop-
erly. Secure with three screws.
Secure in place
using three
stand-offs.
Page 5.621