Table of Contents
Advertisement
Sept 95
INSTALLING SNEAKY KNEKT MODULE IN THE MAJIK / WAKONDA
INSTALLING KNEKT SNEAKY DRIVERS / RECEIVERS
Before starting, you must ensure that you have a clean workbench
and take the necessary anti-static precautions.
Always wear an anti-static wrist strap. Refer to the Service Manual (5.8) for full
details of the necessary working practices.
Note: This procedure is the same for the MAJIK or the WAKONDA, so from
here, the procedure will refer only to the MAJIK..
Always disconnect the MAJIK from everything, ESPECIALLY MAINS, be-
fore fitting a SNEAKY module.
Parts required:
Tools required:
Procedure
1.
Unpack and check the contents of your KNEKT Sneaky
(See contents list in box.)
2.
On a clean bench, and with a
protective pad to protect the
facia, turn the MAJIK upside
down, remove the four screws
and slide off the outer sleeve.
3.
With the MAJIK sitting on its
feet again, remove the two
screws on the back-panel, and
take off the Sneaky slot blank-
ing plate.
4.
Push-fit the two white plastic stand-offs into the holes in the MAJIK main
PCB until they audibly 'click' and lock into position. (See drawing 2)
D
RAWING
KNEKT SNEAKY MODULE (DRIVER OR RECEIVER)
No.1 Pozidrive screwdriver
Small Pliers
2
Copyright © 1995 by Linn Products Limited. All Rights Reserved.
REVISION 14: MAJIK and WAKONDA
Time required:
20 min, approx.
D
1
RAWING
Page 5.617
Hide quick links:
Advertisement
Table of Contents
