Table of Contents
Advertisement
REVISION 14: MAJIK and WAKONDA
INSTALLING AKTIV MODULES IN THE MAJIK- / WAKONDA
9.
Stick the correct identification label onto the lower left hand corner of the
SNEAKY Aktiv module tray.
10.
Remove the shorting links between the PRE-OUT and POWER-IN
Sockets.
LABEL
11.
If the MAJIK is being used as the pre-amp in the system, fit 2 dust caps over
the POWER-IN sockets.
Alternatively, if the MAJIK is being used exclusively as the power-amp in
the system, fit 2 dust caps over the PRE-OUT sockets.
When the Aktiv cards are fitted in the SNEAKY slot they form the link between
the Pre-Amp and the Power -Amp sections of the Majik.
NEVER LINK THE PRE AND POWER SECTIONS EXTERNALLY (EITHER
DIRECT OR THROUGH ANOTHER POWER-AMP) WHEN AKTIV BOARDS
ARE FITTED AS DAMAGE WILL RESULT.
12.
Refit the sleeve.
Page 5.612
Copyright © 1995 by Linn Products Limited. All Rights Reserved.
Sept 95
REMOVE
LINKS OR
BANG!!
Hide quick links:
Advertisement
Table of Contents
