Pppoe Rtadd - THOMSON SpeedTouch 580 Cli Reference Manual

PPPoE Commands

pppoe rtadd

Automatically add a route configuration to the routing table in case the specified PPPoE interface link comes up.
This route configuration will determine which local hosts are allowed to use this link and/or which remote destinations
should be or should not be reachable.
Use the command pppoe ifdetach for this interface prior to configuring routes.
Note
SYNTAX:
pppoe rtadd
where:
intf
dst
dstmsk
label
src
316
intf = <intfname>
dst = <ip-address>
[dstmsk = <ip-mask(dotted or cidr)>]
[label = <string>]
[src = <ip-address>]
[srcmsk = <ip-mask(dotted or cidr)>]
[metric = <number{0-100}>]
The name of the PPPoE interface.
The destination IP address for the route to be added when the link comes
up.
The destination IP mask.
Depending on the destination netmask:
•
Any remote destination is reachable, i.e. the PPPoE connection acts
as default route (dstmsk=0)
•
Only the remote (sub)net is reachable (dstmsk=1)
• The actual destination mask will be the default netmask applicable
for destination IP address
•
Only the single remote host is reachable (dstmsk=32)
•
Any valid (contiguous) netmask in case of Variable Length Subnet
Masking (VLSM).
The name of the label.
The source IP address specification for the route to be added when the
link comes up.
REQUIRED
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040216-0003 v1.0