THOMSON SpeedTouch 580 Cli Reference Manual page 248

Label Commands
prot
srcport
srcportend
dstport
dstportend
clink
log
label
246
The protocol (name or number) expected in the IP packet.
Select one of the following protocol names:
•
icmp
•
igmp
•
ipinip
• tcp
• udp
• ah
•
esp
•
ipcomp
or, alternatively, specify the protocol number.
The TCP/UDP port (or beginning of range) the packet is coming
from.
Select one of the supported TCP/UDP port names (See
" Supported TCP/UDP Port Names" on page 418
TCP/UDP port names supported by the SpeedTouch™).
Alternatively, specify the protocol number.
The source TCP/UDP port range end (inclusive) (only applicable for
ranges).
Select one of the supported TCP/UDP port names (See
" Supported TCP/UDP Port Names" on page 418
TCP/UDP port names supported by the SpeedTouch™).
Alternatively, specify the protocol number.
The TCP/UDP port (or beginning of range) the packet is going to.
Select one of the supported TCP/UDP port names (See
" Supported TCP/UDP Port Names" on page 418
TCP/UDP port names supported by the SpeedTouch™).
Alternatively, specify the protocol number.
The destination TCP/UDP port range end (inclusive) (only
applicable for ranges).
Select one of the supported TCP/UDP port names (See
" Supported TCP/UDP Port Names" on page 418
TCP/UDP port names supported by the SpeedTouch™).
Alternatively, specify the protocol number.
The name of the chain to be parsed when this rule applies.
Logging is done when this rule applies.
Choose between no or yes.
Choose between:
•
None
•
link (when clink is used)
•
label name.
OPTIONAL
OPTIONAL
for a listing of
OPTIONAL
for a listing of
OPTIONAL
for a listing of
OPTIONAL
for a listing of
OPTIONAL
OPTIONAL
REQUIRED
E-DOC-CTC-20040216-0003 v1.0