THOMSON SpeedTouch 580 Cli Reference Manual page 311

servicename
pcomp
accomp
trace
concentrator
auth
restart
retryinterval
passive
silent
echo
E-DOC-CTC-20040216-0003 v1.0
The Service Name for a PPPoE connection.
Use the command pppoe ifscan to see the available service names, if any.
Try (on) or do not try (off) to negotiate PPPoE protocol compression
(LCP PCOMP). The default is off.
Try (on), do never try (off) or negotiate (negotiate) to negotiate PPPoE
address & control field compression (LCP ACCOMP).
In most cases, LCP ACCOMP should not be disabled nor negotiated, i.e.
the address field FF-03 should not be sent over ATM.
The default is on.
If the accomp parameter is set to 'negotiate', the local side of the PPPoE
connection demands to do ACCOMP and adapts itself to the result of this
negotiation.
Enable (on) or disable (off) verbose console logging.
The default is off.
The access concentrator is on this side of the PPPoE connection.
Choose between:
•
on: the PPPoE connection is terminated on the Access
Concentrator (here the SpeedTouch™ itself)
• off: the SpeedTouch™ is PPPoE client.
The default is off.
Select the authentication protocol.
Choose between:
• pap: Password Authentication Protocol (PAP) authentication will be
forced.
•
chap: Challenge Handshake Authentication Protocol (CHAP)
authentication will be forced.
• auto: CHAP authentication will be used. If CHAP authentication is
not successful, PAP authentication will be used instead.
The default is auto.
Automatically restart the connection when Link Control Protocol (LCP)
link goes down (on) or do not restart automatically (off).
The default is off.
A number between 0 and 65535 (seconds).
Represents the intermediate interval between two retries to establish the
connection on ATM level. The default is 10.
Put the link in listening state in case LCP times out (on) or not (off).
This parameter allows to determine whether the link should be left open
to wait for incoming messages from the remote side after 10 unsuccessful
tries to establish the connection or not.
The default is disabled.
Do not send anything at startup and just listen for incoming LCP messages
(on) or retry up to 10 times to establish the connection (off).
The default is off.
Send LCP echo requests at regular intervals (on) or not (off).
The default is on.
PPPoE Commands
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
309