THOMSON SpeedTouch 580 Cli Reference Manual page 31

[<configuration>.ini] paragraphs
[pppoerelay.ini]
[pptp.ini]
[qos.ini]
[script.ini]
[snmp.ini]
[switch.ini]
[system.ini]
[upnp.ini]
[wireless.ini]
CLI Commands in Service Template Files
CLI commands in a paragraph of a Service Template file should always be constructed in their complete form.
Uncompleted CLI commands, i.e. commands in which required parameters are not specified, will be discarded by the
CLI commend interpreter. This may result in a wrongly configured SpeedTouch™.
In Service Template files, the use of customization variables allow the Setup wizard to invite the end-user to provide
some input regarding the settings of the SpeedTouch™. The declaration of such customization variables must be done
in the [env.ini] paragraph of the Service Template file. A preset (i.e. default) value can be declared for a
customization variable. Further use of these customization variables is allowed through all other paragraphs, even
several times.
When a customization variable is used in a CLI command, the value of the variable must always conform to the syntax
of the CLI command.
Customizing Service Template Files
For more information on the customization possibilities of the SpeedTouch™, the Setup wizard and the
configuration profile files, please check the SpeedTouch™ support pages at:
E-DOC-CTC-20040216-0003 v1.0
Available SpeedTouch™ CLI commands
The pppoe relay CLI command subgroup
The pptp CLI command group
The qosbook CLI command group
The script CLI command group
The snmp CLI command group
The switch CLI command group (only for SpeedTouch™ devices with a
four port switch).
The system CLI command group
The upnp CLI command group
The wireless CLI command group
www.speedtouch.com
CLI Navigation
29