Table of Contents
Advertisement
Configuring the Switch using the CLI
The Switch can be managed through the TCP/IP Telnet protocol. The
Command Line Interface (CLI) can be used to configure and manage
the Switch via TCP/IP Telnet protocol.
This section provides a reference for all of the commands contained in
the CLI.
IP Address of the Switch
The Switch IP address can be automatically set using DHCP protocols,
in which case the actual address assigned to the Switch must be
known. You can use the Web Management Utility to get or setting the
IP address of the Switch.
Figure 48. Web Management Utility
54
Advertisement
Table of Contents
