Table of Contents
Advertisement
3.
Match successfully, which mean the first scanner work under
networking; it is "one to one mode".
4.
Matching the second receiver,
(1)
Pull out the second receiver's USB line from PC, please make sure
the USB line and receiver connect well, and receiver's antenna is
connected well too.
Scanner read the barcode on this manual, "one to two pairing"
(2)
barcode (please see the barcode for common function setting on this
manual.)
(3)
After scanning, connect the receiver's USB line to PC within 5
seconds.
If scanner buzzer "Di-Di-Di" three ticking sounds, which mean
(4)
matching successfully; if scanner buzzer "Di-Di-Di-Di-Di-Di" six
ticking sounds, which mean failure.
If match successfully, "one to two mode" networking setting
(5)
successfully.
(6)
If fail to match, please repeat above step (1), (2), (3) to reset.
Part Eleven: Barcode For Common Function Setting
One
on
One
scanning
this
original
matching
unusable;
scanner
according to new matching mode.
One to Two pairing", for setting
one to two mode, when setting
the second receiver, please scan
this command.
20 seconds without any scanning
auto off: for setting scanner auto
shutdown time.
pairing,
after
command,
the
mode
is
will
do
H Y C O C M D -
H Y C O C M D -
H Y C O C M D -
8
M G
M G A
S 2 0
Advertisement
Table of Contents
