Part Seven: Power Off; Part Eight: Lower Power Alarm; Part Nine: Re-Charge; Part Ten: Matching (Networking) - Lixmark D90E series User Manual

interfere from other wireless equipments.
Solving methods: first one, shorten the distance between scanner and receiver;
second one, it is no need to do other operation, scanner can turn to other
channel automatically, until send out successfully.

Part Seven: Power Off

When user needs the scanner stop working temporary, just keep on pressing the
button on scanner over 20 seconds, it will be turned off.

Part Eight: Lower Power Alarm

During scanner reading barcode, buzzer constantly "Di-Di-Di" three ticking
sounds, which mean the scanner need to re-charge.

Part Nine: Re-Charge

Close the scanner; insert the round port of recharger into the bottom of scanner,
then connect it to power source to start recharging. If scanner is not closed,
indicator light will be on all the time; if the scanner is closed or low battery,
indicator light can be flashing. Re-charging time is about 2 hours and a half,
power indicator light will be flashing; during re-charging, this light is on all the
time.

Part Ten: Matching (Networking)

When out of factory, scanner has matched well with relative receiver; usually
user is no need to match again. If need, please follow up the following steps to
match,
1. Open the scanner
2. Pull out the receiver's USB line from PC, please make sure the USB line
and receiver connect well, and receiver's antenna is connected well too.
Scanner read the barcode on this manual, "one on one pairing" barcode
3.
(please see the barcode for common function setting on this manual.)
4. After scanning, connect the receiver's USB line to PC within 5 seconds.
If scanner buzzer "Di-Di-Di" three ticking sounds, which mean matching
5.
successfully; if scanner buzzer "Di-Di-Di-Di-Di-Di" six ticking sounds,
which mean failure.
6. If match successfully, scanner and relative receiver can start
6