Table of Contents
Advertisement
Special Features
Copying your Tapes to
S-VHS or VHS Cassette
Source
(Playing)
Palmcorder
A/V Cable
(Supplied)
S-Video
Cable (not
supplied)
To Audio In
To Video In
To S-Video In
(If there is S-Video In)
Monitor with your TV
• Turn the TV ON and select its VCR
channel (either CH3 or CH4).
• Set the VCR/TV Selector on the
recording VCR to VCR.
50
100-K.46-52.p65
Before you begin...
• Connect both Palmcorder and VCR to their
• Connect the Palmcorder to a VCR as
• Turn ON both units.
• Set the recording VCR's Input Signal
• Set the Palmcorder POWER Switch to VCR.
A/V OUT
S-VIDEO OUT
1
2
TV
(To View)
3
VHF Connecting
Cable (not
supplied)
Video In
Audio In
Recording:
VCR (Rear)
4
5
S-Video In
• For technical reasons, dubbing a tape may
• Press DISPLAY on the Palmcorder remote
• If the Time Code is displayed in the EVF or LCD
50
power sources.
illustrated below.
Selector to LINE.
Insert a pre-recorded tape
into the source (playing) Palmcorder
and a blank tape, with record tab in
place, into the target VCR (Recorder).
Press PLAY on the Palmcorder. When
the tape reaches the point you want to
start dubbing, press PAUSE.
Press REC or simultaneously REC
and PLAY (depends on VCR) and then
pause the recorder.
REW
PAUSE/STILL STOP
VCR Buttons
Simultaneously, press PAUSE on
both units to begin the copying.
Press STOP on both units when
copying is completed.
Note
reduce its quality.
control (optional, page 57) to eliminate EVF/LCD
Monitor indications to be recorded on the tape.
monitor, this display cannot be reset.
CAUTION:
Unauthorized exchanging and/or copying of
copyrighted recordings may be copyright
infringement.
00/06/14, 11:57
PLAY
FF
REC
Advertisement
Table of Contents
