Copying Your Tapes To S-Vhs Or Vhs Cassette Eee - Panasonic Digital Palmcorder PalmSight PV-DV600 Operating Instructions Manual

Special Features
Copying your Tapes to
S-VHS or VHS Cassette
Source
(Playing)
Palmcorder
AN OUT
S-VIDEO OUT
(Supplied) (To View)
VHF Connecting
Cable (not
supplied)
S-Video
Cable (not
supplied)
Audio In Video In
To Audio In
S-Video In
To Video In
To S-Video In
(if there is S-Video In)
Monitor with your TV
* Turn the TV ON and select its VCR
channel (either CH3 or CH4).
* Set the VCR/TV Selector on the
recording VCR to VCR.
Recording:
VCR (Rear)
Before you begin...
* Connect both Palmcorder and VCR to their
power sources.
* Connect the Palmcorder to a VCR as
illustrated below.
* Tum ON both units.
* Set the recording VCR's Input Signal
Selector to LINE.
* Setthe Palmcorder POWER Switch to VCR.
into the source (playing) Palmcorder
and a blank tape with record tab in
place into the target VCR (Recorder).
2 Set SELECT to OUT.
3 Press PLAY on the Palmcorder. When
the tape reaches the point you want to
start dubbing, press PAUSE.
4 Press REC or simultaneously REC
and PLAY (depends on VCR) and then
pause the recorder.
PAUSE/STILL STOP REW PLAY FF REC
VCR Buttons
Simultaneously, press PAUSE on
both units to begin the copying.
6 Press STOP on both units when
copying is completed.
* For technical reasons, dubbing a tape may
reduce its quality.
* Press DISPLAY on the Palmcorder remote
control (optional, page 74) to eliminate EVF/LCD
Monitor indications to be recorded on the tape.
* If the Time Code is displayed in the EVF or LCD
monitor, this display cannot be reset.
CAUTION:
Unauthorized exchanging and/or copying of
copyrighted recordings may be copyright
infringement.
61
Y)
a
©
a
=
mt
(D
e
e
C
ium. 1
M
N