Table of Contents
Advertisement
5.
Position the seat assembly atop the seat track on the seat post. Lightly grease the end of the
threads on an adjustment lever. Loosely thread the adjustment lever through the brass washer,
through the hole in the seat track, and into the seat assembly. Slide the seat to the desired position
and tighten the adjustment lever.
Note: The handle on the adjustment lever has a
ratchet function. Once you have tightened
a lever, pull out on the handle and rotate it
so it does not stick out. Release the handle
to lock it into place.
6.
Position the handlebar on top the handle-
bar track. Lightly grease the end of the
threads on an adjustment lever. Loosely thread the adjustment lever through the brass washer and
into the hole in the handlebar. Slide the handlebar to the desired position and tighten the adjust-
ment lever. (Use the adjustment lever's ratchet function as necessary.)
Brass
Washer
7.
The pedals are marked as if you are seated on the bike, "R" for right, and "L" for left.
pedal is reverse-threaded. Carefully thread the right pedal into the crank arm with your fingers - do
not cross thread the pedal in the crank arm! Use the included mulit-tool or a15 mm pedal wrench
tool to tighten the pedals. Repeat this step for the left pedal.
8.
To install the bottle holder, align the bottle holder mounting bracket on the handlebar and attach
with two (2) M 4 X 10 mm screws. Tighten with a hex key.
12
Adjustment
Handle
ASSEMBLY INSTRUCTIONS
Brass
Washer
Adjustment
Pull Out and Rotate
Lever
Note: The brass washer must be
installed so the handlebar can be
adequately tightened before use.
Note:
The left
Hide quick links:
Advertisement
Table of Contents
