Film-Tech SA10 Installation Manual page 68

OUTPUT LEVEL
LEFT CENTER
SURROUND SURROUND
Cat.No. 810
Bs = 85 dBC
64 64 Mic Mic
The alignment is now complete.
On the front panel, press the Surround Enable switch
to the enable (out) position.
On the SA10 inside front panel, press the Alignment
switch to the alignment (out) position. The red LED
on the front panel should light indicating that the
SA10 is in Surround EX mode.
RIGHT
SURROUND
Adjust the SA10 Back Surround output level control
to obtain a reading of 85dBC.
On the SA10 inside front panel, press the Alignment
switch to the normal (in) position.
On the CP45 press the format 64 (Mic) button to shut
off the pink noise.
Plug the control cable back into the SA10 rear panel
connector J3
Alignment With CP45 / 6-9