Film-Tech SA10 Installation Manual page 14

1.5.3
If your Cat. No. 810 card contains switches, they should not be moved. The figure below
shows the factory settings:
If your Cat. No. 811 card contains jumpers or pots, they must not be adjusted. Changing
the factory settings will affect the calibration of your SA10.
DO NOT ADJUST
Note: Your Cat. No. 811 may not contain the unused jumpers and pots shown in this figure.
1.6 Connect Power
Plug the transformers into mains power.
1. With the front panel Power switch set to the Normal position, verify that the
Backup LED turns off approximately three to five seconds after the application of
power.
2. Set the Power switch to Backup position. The bypass LED on the front panel
should blink.
3. Return the Power switch back to the Normal position and apply power to the
other projection room equipment.
Other Jumpers/Switches/Pots
Note: Your Cat. No. 810 may not contain the unused pots shown in this figure.
SWITCHES NOT USED
NOTE CORRECT POSITIONS
Cat. No. 810
POWER INDICATORS
VOLTS
+6.7V -6.7V
+12V -12V
Cat. No. 811
Setup / Installation / 1-5
L B S R S
S