Film-Tech SA10 Installation Manual page 34

Back Left
Back Right Amp
Back Left Amp
Bs = 85 dBC
Back Right
Rs+Bs = 82 dBC
R
Ls Channel
Ls+Bs = 82 dBC
L
Ms Channel
Turn on or restore the Bs, Back Surround, channel
signal.
Using the level control on the Bs
Right) amplifier, adjust the level to obtain 82 dBC.
Use the CP500 fader knob to select the Ls channel to
enable the pink noise for that channel.
Do not adjust the output level of the CP500.
Using the level control on the Bs
Left) amplifier, adjust the level to obtain 82 dBC.
On the SA10 front panel, press the Surround EX
Mode switch to the Enable (out) position.
On the inside of the SA10 front panel, press the
Test/Normal switch to the Test (out) position.
The red LED on the front panel should light, indicating
that the SA10 is in Surround EX mode.
Use the CP500 fader knob to select the Ms channel.
On the SA10, adjust the output level control for the Bs,
Back Surround, channel to obtain 85dBC.
Alignment With CP500 / 2-11
(Back Surround
R
(Back Surround
L