Wakeup Format Fix - Film-Tech SA10 Installation Manual

5-10 / Alignment with CP55
The alignment is now complete.
5.5

Wakeup Format Fix

Regardless of the wake-up format previously selected via the Cat. No. 243 jumper, after the
SA10 is installed the CP55 wakes up in digital format with mute on. Since, in any practical
theatre, a film format is selected for the start of the show; this should cause no problems with the
presentation of the show. If, however, you prefer that the CP55 wake up in the jumper-selected
mode, such as for playing music before the first show of the day, you will need to do the
following.
Cat. No 243
Jumper Wire
Remove the Cat. No. 85 and reinstall the Cat. No. 150
card.
Remove the Cat. No. 243 card from the CP55.
Hold the card with the component side up and the edge
connector to the left.
Locate resistor R98, ½W 2.2KΩ, on the upper right
corner of the card.
On the other side of the board, solder a jumper wire
across the resistor, shorting out it out. There is no need
to actually remove the resistor. Be careful to avoid any
shorts with solder splashes.
Reinstall the board into the processor, and check that
the wake-up format is correct and the processor is not
muted after power-up.