Film-Tech SA10 Installation Manual page 43

3-8 / Alignment with CP65
Cat. No. 441
Rs -- GND Jumper
Cat. No. 242
Ls -- GND Jumper
Back Left (Bs )
R
Ls = 83 dBC
Rs = 83 dBC
Back Right (Bs )
L
On the front panel, press the Surround Enable switch
to the disable (in) position. The red LED on the front
panel should go off indicating that the SA10 is in
conventional 5.1-channel mode.
Confirm that the front panel fader is set to 7.
Connect the grounded jumper wire to the Rs (yellow)
test point on the Cat. No. 441. This will mute the Rs
pink noise.
Adjust the SA10 output level control for the Ls
channel to obtain 83 dBC in the theatre.
Move the jumper wire to the Ls (white) test point on
the Cat. No. 242. This will mute the Ls pink noise.
Adjust the SA10 output level control for the Rs
channel to obtain 83 dBC in the auditorium.
Turn on the Back Surround channel amplifiers.