Film-Tech SA10 Installation Manual page 44

Back Right Amp
Cat. No. 441
Rs -- GND Jumper
Back Left Amp
Remove Jumper
Rs+Bs = 85 dBC
R
Ls+Bs = 85 dBC
L
Bs = 88 dBC
Using the level control on the Bs
Right) amplifier, adjust the level to obtain 85 dBC.
Connect the grounded jumper wire to the Rs (yellow)
test point on the Cat. No. 441. This will mute the Rs
pink noise.
Using the level control on the Bs
Left) amplifier, adjust the level to obtain 85 dBC.
Remove the jumper wire from both test points.
On the front panel, press the Surround Enable switch
to the enable (out) position
On the SA10 inside front panel, press the Alignment
switch to the alignment (out) position. The red LED
on the front panel should light indicating that the SA10
is in Surround EX mode.
Adjust the SA10 Back Surround output level control
to obtain a reading of 88dBC.
On the SA10 inside front panel, press the Alignment
switch to the normal (in) position.
Alignment With CP65 / 3-9
(Back Surround
R
(Back Surround
L