Film-Tech SA10 Installation Manual page 33

2-10 / Alignment With CP500
On the front panel, press the Surround Enable switch
to the disable (in) position. The red LED on the front
panel should go off indicating that the SA10 is in
conventional 5.1-channel mode.
Use the CP500 fader knob to select the Ls channel to
enable the pink noise for that channel.
Ls Channel
Do not adjust the output level of the CP500.
On the SA10 adjust the output level control for the Ls
channel to obtain 80dBC in the auditorium with the
SPL measuring device in the exact center of the width
of the theatre.
Ls = 80 dBC
Use the CP500 fader knob to select the Rs channel to
enable the pink noise for that channel.
Rs Channel
Do not adjust the output level of the CP500.
On the SA10 adjust the output level control for the Rs
channel to obtain 80dBC.
Rs = 80 dBC