Table of Contents
Advertisement
FIG. 8A
FIG. 8B
FIG. 8C
Flat Four Conductor Cable
Important:
RJ-11-6C4P connectors must be installed
as shown in FIG. 8A, 8B & 8C.
3. Comfort Control Center
a. Carefully remove the base plate from the Com-
fort Control Center
plished by inserting a small screwdriver under
the tab on the bottom edge of the front cover
and gently prying. See FIG. 9.
b. Insert the control cable through the hole in the
base plate and mount the plate to the wall with
two (2) screws provided. Check the alignment to
ensure level installation.
c. Install the control cable RJ-11-6C4P connector
into the back of the Comfort Control Center™
and snap onto the base plate. See FIG. 9.
FIG. 9
D E
D E
M O
M O
N
N
F A
F A
P
P
U P
U P
T E M
T E M
W N
W N
D O
D O
N E
N E
Z O
Z O
O N
O N
F
F
O F
O F
Insert Screwdriver
Insert Screwdriver
under Tab
under Tab
Pin 1
RJ-11-6C4P
Connector
TM
Installation
TM
. This may be accom-
620515, 620525, 620526, 630515 & 630516 Installation Instructions
F. Placing Air Conditioner On The Roof
FIG. 10
This unit weighs approximately 100 pounds.
To prevent back injury, use a mechanical hoist
to place Air Conditioner on roof.
1. Remove the air conditioner from the carton and dis-
card carton. See FIG. 10.
2. Place the air conditioner on the roof.
Do not slide the unit. This may damage the
roof gasket attached to the bottom and may
create a leaky installation.
FIG. 11
FRONT
3. Lift and place the unit over the prepared opening using
the gasket on the unit as a guide. See FIG. 11.
4. Place the Return Air Kit inside the RV. This box
contains mounting hardware for the air conditioner
and will be used inside the RV.
This completes the outside work. Minor adjustments
can be done from the inside of the RV if required.
9
CAUTION
Hide quick links:
Advertisement
Table of Contents
