Door Panel; Membrane Keypad - GE GLD8110 Technical Service Manual

Door Panel

The door panel covers the main control board, detergent cup, vent, wax motor, louver, and door-interlock switch.
The outer door panel is held in place by 14 screws (7 Phillips head screws per side ).
Note: Ribbon cable(s) connect the keypad membrane (2-digit display on some models) to the control board. Due to
the ribbon length, care must be taken when removing the door panel to ensure that the ribbon cable(s) are not
damaged.

Membrane Keypad

The door panel must be removed to access the membrane keypad (see
When removing the membrane keypad, peel the keypad from right to left.
When installing, make sure the membrane button areas and lights align with the keypad.
On models with an LED display, the display is held in place plastic clip.
Note: When replacing the keypad membrane, always run the Test mode calibrate the keypad membrane to the
control board.
Door Panel
‐ 19 ‐
).