Control Board - GE GLD8110 Technical Service Manual

Control Board

The door panel must be removed to access the control board (see
considered a "smart" control, capable of learning the water temperature and turbidity characteristics of the home.
It is normal if the cycle times vary over a period of time from the factory default settings due to temperature and water
quality.
The control module is held in place by two screws that secures the module to the right side of the
inner door panel.
Control Board
P2-1 – Rinse Aid Sensor(on some models), P2-2 – Thermostat,P2-3 – Inlet Valve, P2-4 – Dispenser, P2-6 – Door
Interlock Switch(Double Black Wires), P3 – Drain motor, P5&P9 – Washing Motor, P6 – Heater Element, P7 – Door
Interlock Switch(Double White Wires), P8 – Door Interlock Switch(Single Black Wire), P10 Wax Motor connector,
CN1+CN6 – Door Panel, CN2 – Display Board.
D
oor Panel ). The main control is
‐ 20 ‐