Control Panel; Dishwasher Components; Outer Door Panel; Static Dry System - GE GLDT690T Technical Service Manual

Outer Door Panel

The outer door panel covers the door to the
dishwasher and must be removed to access the
control panel, detergent/rinse module, bottom door
seal, and heating element.
To remove the outer door panel, remove 12 Phillips-
head screws, and then lower the door panel from
the control panel.

Control Panel

To remove the control panel:
1. Remove the outer door panel. (See
Panel.)
2. Remove 2 Phillips-head screws from door latch.

Dishwasher Components

3. Tilt the control panel out to clear lip and remove.
Note: The escutcheon console cover or top trim with
lettering is replaced using adhesive.
The static dry system operates through a vent
located behind the left side door panel. The vent
allows hot air to exit the dishwasher tub and
gradually remove moisture that runs through the
tube and back into the tub.
To remove the static dry system:
1. Remove the control panel. (See
2. Turn the static dry vent cover counterclockwise
Outer Door
– 16 –

Static Dry System

and remove.
.)
Control Panel
Cover
Vent
(Continued next page)