Westinghouse 540 upright cooker User Manual page 28

INSTALLING yOUR ELECTRIC COOKER
WIRING REqUIREMENTS
The cooker MUST be installed in compliance with:
• wiring connections in AS/NZS 3000 Wiring Rules
• local regulations, municipal building codes and other
statutory regulations
• For New Zealand Only: The cooking range must be
connected to the supply by a supply cord fitted with
the appropriately rated plug that is compatible with
the socket-outlet fitted to the final sub-circuit in the fixed
wiring that is intended to supply this cooking range.
Data plate
Circuit diagram
• A functional switch MUST be provided near the
appliance in an accessible position (AS/NZS
3000:2007 Clause 4.7).
• Wiring MUST be protected against mechanical failure
(AS/NZS 3000:2007).
• The cooker requires a means of all pole disconnection
incorporated into the fixed wiring.
This MUST have a disconnection gap of 3mm.
• The cooker MUST be properly earthed.
ImpOrTaNT: Before you cook in your new oven it is
important that the protective oils used in the manufacture
of the product be removed. refer to 'Before Operating your
appliance for the First Time' in the Using The Oven Section.
28
INSTALLATION
• gives information about rating
• is located behind the bottom of the
oven door
• is located on the back panel
of the appliance
HARd WIRING dETAIL
1 Remove rear cover
2. Fit wires through hole at bottom centre using the
appropriate gland to protect insulation of wires from hole
edge. Note that the secondary insulation of the wires will
probably need to be removed to fit through gland. If the
conduit to appliance is required to bend due to rear wall
an elbow may be required to achieve this.
3. Set the length of wiring from gland to terminal block
ensuring length is sufficient but not excessive.
4. Make connections to terminals and engage wires
into plastic clip and cable tie as per diagram. Secure
plastic clip with two long screws (supplied in separate
plastic bag).
5. Replace rear cover.
IMPORTANT: Ensure wires cannot come into contact with
ends of hot elements or sharp edges.
Note: When connections are made to a multi-phase
230/240V supply, the bridge piece mUST be removed
from between the active connections, as shown below.
Gland
Plastic Clip
Plastic clip scre w
securing points
Cable Ti e