Westinghouse 540 upright cooker User Manual page 27

fITTING THE ANTI-TILT PLATE & STAbILISING bOLT
COOKER STAbILITy
Note: To ensure cooker stability, both the anti-tilt plate
and stability bolt mUST be installed on all cookers
(electric and gas).
INSTALLATION SEqUENCE
1. The cooker is delivered with the anti-tilt plate attached
to the back panel. Unscrew from back panel and
locate the anti-tilt plate against the rear wall. If locating
between 2 cupboards, then fit the plate in the centre
of the space. If locating the cooker at the end of a
cupboard, then position the side of the plate 25mm
from the cupboard.
Note: If cooker cannot be located against rear wall, move
anti-tilt plate forward to suit.
2. Securely fix the anti-tilt plate to the floor with
appropriate fasteners.
3. Slide the cooker back into the anti-tilt plate so that rear
cover rests against the rear wall.
Then check the height and level of the cooker. If
required, pull the cooker back out and adjust the
levelling feet as required.
4. Fasten the stability bolt bracket to the front frame with
the 2 screws supplied.
5. Reposition the cooker back into the anti-tilt plate and
then mark the position of the stability bolt hole.
6. Pull the cooker back out and drill the bolt location hole.
Use a 6.5mm masonry or wood drill. When drilling into
concrete ensure a minimum hole depth of 30mm.
7. Connect gas and electricity supply
(refer to pages following).
8. Reposition the cooker back into the anti-tilt plate,
aligning the stability bolt bracket with the 6.5mm
drilled hole. Then slide the bolt through the bracket
and into the hole.
9. Fit the kick panel onto the cooker by aligning the 2
location holes on the kick panel with the top kick panel
clips. Then push the bottom of the kick panel inwards until
it clips home.
REMOvING THE KICK PANEL – SMALL TyPE
To remove the kick panel, firstly position one hand
underneath and to one side of the kick panel.
Then pull the kick panel upwards and the top of the panel
outwards to disengage the top of the kick panel from the
top clip.
Then do the same on the other side of the kick panel to fully
disengage it.
To replace the kick panel, locate panel over the top clips
and push the bottom of the kick panel inwards until it clips
home both sides.
REMOvING THE KICK PANEL – LARGE TyPE
Hold kick panel at top on either side and pull outwards to
release from clips.
To replace, locate top of panel to clips and push bottom
until it clips home.
Plate
27
INSTALLATION