Table of Contents
Advertisement
rrinrtng tnveiopes
Printing Envelopes Using Generic Instructions
For the H P LaserJet IIISi:
1 Enter the default envelope size (COM-10, Monarch,
DL)
into your
software program. If your software does not allow you to select a
default envelope size, enter the size into the printer's control
panel by following these steps:
a Click
m
to take the printer offline.
b Click
once.
FC:L
(or
P : ; )
PF:I
t.4-r
PiEtN,
then
COFIES=l + appears in the display.
c
Click
repeatedly (after
i : i : i P I
ES= 1
*)
until
PFIPER=
[size] +
(LETTER, LEGkl-,
k4, EZ::EC)
appears.
d Click
El
until
Et.IUELOPE=
[size]
(COPl19, PKi t .IFi R C:, DL)
appears.
e
Click
L3
until the desired envelope size appears in the display
(COtIlQ, MONFI R i : ,
DL).
If your envelope size is not listed, choose
the next largest size (refer to table 2-1 for envelope sizes).
f Click
m
to save your selection. An asterisk
"*"
appears in
the display. Leave the printer offline.
2
Enter landscape orientation into your software application. If
your software does not allow you to select orientation, select
landscape orientation from the control panel by following these
steps:
a Click
once.
t~iF;IEt.~TRTIOt.~=P
+ appears.
b Click
p31
to select
1-
for landscape. The display reads
ORIEt4TFITIOt+L.
c
Click
m
to save your selection.
An
asterisk
": e "
appears in
the display.
d Click
m.
The display should read
Ki d PC'L f?fZFi[:.V
(or
69
FS
REFIDC).
You have completed entering commands into the
control panel.
3 Set the margins for your address in your software application:
Advertisement
Table of Contents
