Connecting To Shore Power - Bayliner 285 Cruiser Owner's Manual

285 • Owner's Manual Supplement

Connecting To Shore Power

NOTE: SINGLE INLET STANDARD
DUAL INLETS WITH AIR CONDITIONER
(IF EQUIPPED)
LINE 1
DOCKSIDE MASTER
LINE 1
POLARITY
LIGHT
10 AMPS
20 AMPS
5 AMPS
25 AMPS
1. Review all hazard information at the beginning of this section, Shore Power/120V/60Hz AC System.
2. Turn Off all breakers and switches on the AC master panel.
3. Attach the shore power cord to the boat inlet first then to the dockside outlet.
4. Monitor the AC panel's polarity indicator lights, located below the line master breaker(s), as follows:
•
A green light illuminating after the power cord is plugged into the dockside outlet indicates acceptable electri-
cal power. You may turn On the master breaker switch.
•
A red light, however, indicates reversed polarity, which could cause electrical system damage and possibly
electrical shock injuries. In this case, do not turn On the master breaker switch.
SHORE POWER
INLET(S)
DUAL SHORE POWER AC PANEL (IF EQUIPPED)
VOLTMETER
SELECTOR SWITCH VOLTMETER
FIGURE 1
Chapter 2: Features / Systems
LINE 2 LINE 2
TRANSFER DOCKSIDE MASTER
TYPICAL SHORE
POWER INLET
LINE 2
POLARITY
LIGHT
15 AMPS
15 AMPS
15 AMPS
15 AMPS
21