Table of Contents
Advertisement
REATTACH MOTOR ASSEMBLY
11
Slide motor assembly onto arm and secure
with screws (4). NOTE: Turn operator over
to re-install screws. Attach arm cover.
If installing a second gate operator repeat
steps 1-12.
NOTE: The arm brackets must be reversed
or mirrored on the second operator.
ATTACH OPERATOR TO GATE AND BRACKET
12
Make sure "THIS SIDE TO GATE" label faces the gate
when reattaching operator to gate. Tighten all bracket
connections.
FOR MODEL GA420D ONLY
13
Repeat Steps 1-12 for second arm.
WARNING SIGN PLACEMENT
14
Warning placards MUST be installed on both
sides of the gate and in plain view. Fasten to
gate with cable ties.
Gate Post
Fence
Installation
"THIS SIDE TO GATE"
label MUST face the gate.
Gate
Gate Travel
Path
INSIDE PROPERTY
NOTE: Motor housing screws must
be fully tightened with screw heads
Screws
recessed below housing surface.
Motor
Arm
To prevent SERIOUS INJURY or DEATH from a moving gate:
• Install warning signs on the front and back of the gate
CAUTION
in PLAIN VIEW.
• Permanently secure each warning sign in a suitable manner
using fastening holes.
Moving Gate Can Cause
Injury or Death
KEEP CLEAR! Gate may move at any
time without prior warning.
Do not let children operate the gate or
play in the gate area.
This entrance is for vehicles only
Pedestrians must use separate entrance
AVERTISSEMENT
ATTENTION
20
Arm Cover
WARNING
WARNING
Advertisement
Table of Contents
