Advertisement
PARTS DESCRIPTION
1 Handle
9
Remote control storage
2 Left side
10 Rear
3 Power cord
11 Top water tank
4 Castors
12 Air inlet
5 Top cover
13 Water tank
6 Control panel 14 Tank drain
7 Front
15 Mains Switch
8 Air outlet
CONTROL PANEL
-5-
OPERATING INSTRUCTIONS
•
Choose a suitable location for your Evaporative Cooler;
please refer to the Important Product Information for details.
•
Your product may be operated by the manual controls located
on the unit or by the remote control.
FOR ROOM COOLING
•
Turn the product OFF at the MAINS SWITCH and remove the
plug from the mains socket.
•
Open the top cover and pour clean water into tank. The water
level indicator on the front of the Evaporative Cooler shows
the level of water in the tank. Then connect to the power
supply and turn on the MAINS SWITCH.
•
Press the POWER button and the fan will start at medium
speed, after few seconds, it will switch to LOW speed.
•
To turn the product OFF press the POWER button again. If
you do not intend to use the product for some time also turn
off the MAINS SWITCH once the product has stopped and
empty the water tank.
•
Press the SPEED button to increase or decrease the speed.
•
Press the MODE button to select the COOL MODE, indicated
by the LED. The full effect of this mode will begin after about
3 minutes.
•
When the water in the tank has been used refill as above.
•
To empty the water tank turn your product off at the POWER
button and MAINS SWITCH. Carefully pull the tank from the
main body and dispose of the water. Refit the tank correctly
or your evaporative cooler will not work correctly. See Tank
Fitting instructions. Alternatively use the drain at the rear of
the tank.
-6-
Advertisement
