Important
Do not hold down the reset
button for more than five
seconds, unless you want to
erase all of your base station
settings and return them to
the factory defaults.
Base Station Indicators and Controls
The preceding diagram shows the location of all ports, jacks,
controls, and indicator lights on the base station.
The base station contains two antennas, one internal and one
external. The external antenna is adjustable for best wireless
reception.
The front of the base station has seven green (and labeled)
indicator lights. After the base station is connected, these lights
will be on, off, or blinking, indicating the following states.
Light
On
Power
Receiving power
Modem
Modem connected
and on
Wireless
Radio enabled
status
Ethernet
Ethernet device
status (4) connected and on
Resetting the Base Station
To reset the base station to correct temporary connectivity
problems, use a pointed object to briefly press and release the
reset button on the back of the base station, as shown in the
following illustration.
Resetting or Restoring the Base Station
Off
Blinking
Not receiving power
Green or orange during
reset and restore
Modem off or
Data being sent
not connected
or received on modem
Radio disabled
Wireless data being
sent or received
Ethernet device
Data being sent or
off or not connected received over Ethernet
Power Indicator
Light
Chapter 1: Introduction 3