Table of Contents
Advertisement
4 Microsoft Broadband Networking Wireless Base Station User's Guide
Observe the power indicator light, and release the button as soon
as the light turns from green to orange. The light will return to
green when the reset is complete. Do not unplug the base station
during a reset.
Restoring Base Station Factory Settings
To return the base station to its factory default settings (for
example, if you forget your base station password), you can use the
reset button on the back of the base station to clear all base
station settings, restore the default settings, and reset the base
station.
To restore the base station factory settings
1. Use a pointed object to press the reset button on the back of
the base station, while observing the power indicator light. Hold
the button down until the light starts to blink green and orange,
about five seconds.
2. Release the button and wait for the light to turn solid orange
and then green, which can take up to 60 seconds.
Do not unplug the base station during a restore.
Placing and Positioning the Base Station
You can place the base station vertically in the provided stand, as
shown in the following diagram, or horizontally without the stand.
You can also rotate the base station to obtain the best wireless
performance.
Attaching the Base Station Stand
The Microsoft Wireless Base Station must be physically connected
to a power outlet and to your broadband modem, so the base
station should be placed near these.
To place the base station and adjust its antenna for the best
wireless performance, see "Recommendations for Best Wireless
Performance" in this chapter.
Advertisement
Table of Contents
