Table of Contents
Advertisement
2. On the Management menu, click Time Settings.
3. Under Synchronize Time to Internet Time Server, type the IP
address for the specific SNTP server that you want to use, and
then click Add.
4. Repeat step 3 for any additional backup SNTP servers that you
want to specify.
Change the Base Station Password
Access to the Base Station Management Tool is password
protected so that only users who know the base station password
can change your network configuration. If you ran the Setup
Wizard, you were prompted to establish a password. This is your
base station password. If you did not run the Setup Wizard, your
default password is admin. You can change the base station
password from the Base Station Management Tool.
It is a good idea to change your password every two to three
months, or more frequently if you are concerned that an
unauthorized person has administrative access to the base
station.
If at any point you restore the factory default settings for the base
station, the default password admin is also restored. You can use
this password to access the base station, and then create a new
password at the earliest opportunity.
When you change your base station password, be sure to update
your backup file.
To change the base station password
1. Open the Base Station Management Tool, and then click
Management.
2. On the Management menu, click Change Password.
3. In the Current password box, type your current password
4. In the New password box, type in a new password. The base
station password can contain 3–16 alphanumeric characters
and is case sensitive.
5. In the Retype new password box, retype the new password. Do
not use the Copy and Paste commands to add the new
password to the Retype new password box. If you did not type
your password correctly in the New Password box, you will not
know what your password is when you paste it into the Retype
new password box.
6. If you want, in the Log out inactive user in box, type a time
interval. After the specified time interval elapses without
activity, you will need to log on to the Base Station Management
Tool again in order to view or change settings.
7. To save the new password, click Apply.
Chapter 6: Configure 55
Advertisement
Table of Contents
