Manual Preset; Tuning Into A Preset Station - JVC KD-SH99 Instructions Manual

Manual preset

You can preset up to 6 stations in each band
(FM1, FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
FM 1
2
Tune into a station of 88.3 MHz.
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new
station is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
10
1 Press SOURCE
repeatedly to select the
tuner as the source.
2 If necessary, press
BAND (B) repeatedly to
select FM 1.
Each time you press the
button, the band
changes as follows:
FM 2 FM 3
Press ¢
to tune
into stations of higher
frequencies.
4 to tune
Press
into stations of lower
frequencies.
"P1" flashes for a while.

Tuning into a preset station

You can easily tune into a preset station.
Remember that you must store stations first. If
you have not stored them yet, see "Storing
stations in memory" on page 9.
1
Select the band (FM1 – 3, AM).
FM 1
AM
2
Select the number (1 – 6) for the preset
station you want.
If the sound quality decreases and the
stereo effect is lost while listening to
an FM station...
In some areas, adjacent stations may interfere
with each other. If this interference occurs, this
unit can automatically reduce this interference
noise (the initial setting when shipped from the
factory). However, in this case, the sound
quality will be degraded and the stereo effect
will be also lost.
If you do not want to degrade the sound quality
and to lose the stereo effect, rather than to
eliminate the interference noise, see "To
change the FM tuner selectivity – IF FILTER"
on page 27.
When using this until in an area other than
North or South America:
You need to change the AM/FM channel
intervals. See "To change the AM/FM channel
intervals – AREA" on pages 26 and 27.
1 Press SOURCE
repeatedly to select the
tuner as the source.
2 If necessary, press
BAND (B) repeatedly to
select FM or AM.
Each time you press the
button, the band changes
as follows:
FM 2 FM 3 AM