Installation - Ideal-Standard HYGIENE PLUS Manual For Use And Installation

The appliance must be installed by qualified personnel in compliance with current regulations and regulations in
place relative to domestic electrical wiring and plumbing.
The tubs must be installed in dedicated rooms and must NOT be installed outdoors.
The appliance must be connected correctly to the mains power supply, i.e. to the terminals
marked L (line), N (Neutral) and ground
ECOLOGICAL NOTES
Upon completion of the installation phase, please remember to dispose of the packag-
ing and assembly scraps in accordance with standards in effect in the country where
the product will be used.
P
recautIons
In order to ensure correct installation and main-
tenance of the product, the manufacturer rec-
ommends careful attention to the instructions
contained in this manual. Compliance with
safety norms and the suggestions described in
this manual will ensure that the tub functions
perfectly and that the manufacturer's warranty
will be fully applicable.
P -
re InstallatIon checks
Before you start installation it is advisable to:
- check the integrity of the packaging as indicated
on the pack;
- if there is a protective film on the shower box it
must be removed and check that the shower box
surface is neither scratched nor dented
- check that the tube system has not received
blows or been tampered with.
Once the product is installed, the manufacturer
cannot be held liable for any of the damage men-
tioned above.
TT0283660_05_PREMIUM_CMYK.indd 251
, otherwise correct operation cannot be assured.
P
rotectIon durIng Work
When installing the product and during work,
protect the surface of the tub with cardboard or
sheets of plastic to prevent damage caused by
paints, mortar, adhesives, or masonry debris.
I
nstaller
A person who is capable of demonstrating to
pertinent authorities that he has the knowledge
and skill in the application of national regulatory
requirements concerning safety, i.e. electricity,
water supply, and disposal.
I
nstallatIon
The installer is responsible for the choice of materi-
als and complying with standards and laws:
- He must not tamper with the electrical parts of
the tub, he must limit himself to connecting and
installing the components as explained in this
manual.
- He must guarantee that the work done will not
compromise the IP x5 protection level of the tub
components.
- When appropriate, he must install the device(s)
for prevention of backflow in accordance with
EN 1717.
- In the case of a failure or malfunction he must
contact After-Sales Service who will supply
original spare parts.
The manufacturer is not liable if the whirlpool tub
is installed on premises where the structures and
251 251
28/03/11 16.07