Operating Modes - Ideal-Standard HYGIENE PLUS Manual For Use And Installation

o
PeratIng modes
START-Up
Place the switch in position "I";
Fill the tub up to a level which is 5 cm above the
nozzle;
The system is in standby status awaiting user com-
mands.
The status of the LEDs is the following:
- LED 0/I steady red light;
-
water level LED:
- disinfectant level LED:
B Led
umping
v Led
enTuri TuBes
W Led
HirLpooL
T Led
Win
A Led
irpooL
o Led
zone
H Led
ygiene
L Led
igHT
d
isinfecTAnT
L Led
eveL
W
ATer LeveL
0/i Led
30
TT0283660_05_PREMIUM_CMYK.indd 30
insufficient: steady red light;
OK: steady green light;
insufficient: steady red light;
OK: steady green light;
3
FUNCTION ACTIVATION
The activation of the ozone and Venturi tube func-
tions is possible only with the whirlpool in opera-
tion. Maximum operating time for these functions
is set at 45 minutes. When either the Whirlpool
e Airpool function is activated, the elapsed time
countdown begins. If the time limit of 45 minutes is
reached, it means that one or more functions have
been active for the entire time, and the system is
automatically placed in standby status.
LIGHT FUNCTION
(Activates the LED spotlight)
Meaning of LED status
Phase
Light selection/activation
WHEN THE KEY IS PRESSED:
- if no functions are active (0/I LED with steady
red light), press the 0/I key within 5 seconds
(otherwise the light LED will go off ) so that
the LED for the 0/I key comes on with a steady
green light and the spotlight comes on. This will
activate a time limit of 10 minutes.
- if there are functions active (0/I LED with steady
green light), the spotlight comes on;
- if water level in the tub is insufficient, the spot-
light will not come on;
- first touch: the mode "continuous cycle of all
colours" comes on;
- second touch: the function for cyclical change
of colours is interrupted on the colour se-
lected;
- from the third touch on, the colour is manually
changed at each touch.
Sequence of colours: white, red, orange, yellow,
green, blue, indigo, violet.
THE FUNCTION MAY BE TERMINATED (THE LIGHT
LED GOES OFF):
- if light key is pressed for at least 3 seconds;
- if the 0/I key is pressed;
- upon completion of active function (whirlpool, etc.);
- when the 10 minute time limit has expired (only
if no function is active);
led
status
LED with steady
blue light
28/03/11 16.05