Lotus TURBO ESPRIT Service Manual page 420

Page
48 SECTlON LD
Using a 3mn1 allen key, turn the mixture adjustment screw, without ptessing down
the
airflow sensor, until fuel can
i ~ s t
be seen to drip from the iniector. Turn
the
screw
f
turn cwiterclockwise.
rip
inertia switch and remove electrical
tat
bridges.
Refit fuel pump conk01 relays, and reset inertia switch. Remove slave injector and
re-connect injector pipe.
Tempomrily blank off mixture screw access hole whilst following LD
23
procedure to
check duty cycle rate, and adjust
if
necessary as above.
I
-
THROTTLE DOES
NOT OPEN
COMPLETELY
Check that with the accelerator pedal pressed to its fullest extent, the full throttle
stop bracket on the butterfly spindle i s i n contdct with the throttle body abutment.
Adjust throttle pedal downstop as necessary.
J
-
THERMO-TIME SWITCH
To test the switch, remove from the manifold and plug the hole
to
prevent coolant low.
The switching temperature and time period at
-
20° C are stamped on one of the swttch
hexagon
f
lots
.
Them 'G' and Term
'W'
and Term
'G
'
and
O c
Over
I
'Ground' (Housing) 'Ground' term
'W'
- -
I
DeSfgn
1
At a temperature
Measure the reststance between the connection
listed
i n the table after standtng the
swttch i n water at the appropriate tempemture for 10 minutes. Replace swttch tf
necessary.
- -
Resistance measurement i n ohm between