Table of Contents
Advertisement
Page
28
SECTION LD
0
Connect a strobcscopic timing lamp to No.
1
spark plug lead and remove
grommet from clutch bell housing.
Start engine and run until normal operating temperature i s reached (water
temp. above
80O~).
2.
Check idle speed. 950
! :
50 rpm.
D O
NOT
ADJUST IDLE SPEED WITHOUT
FIRST
SLACKENING THROllLE
POSIT1 ON
SWITCH MOUNT1
NG
SCREWS
ON REAR OF
No.
3/4
THROTTLE
BODY.
0
Switch
I f adjustment i s required, f i n t slacken the throttle p i t i o n switch scram, and
then adjust idle speed at the stop screw between throttle bodies
2
and
3.
Idle Speed Stop Screw
Ad jvst
throttle cable to suit i f necessary.
After adjustment, connect continuity meter TOOOT0568 to the throttle position
switch, and rotate switch until continuity i s JUST made. Tighten screws and
recheck setting.
- Quick Links:
- Contents
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
