Dmx Linking; Dmx Modes; Master/Slave Connectivity - Chauvet Q-wash 560Z-LED User Manual

Setup

DMX Linking

You may link the Q-Wash 560Z-LED to a DMX controller using a standard DMX serial
connection. If using other DMX compatible products with this product, you can control them
individually with a single DMX controller.
If you are not familiar with the DMX standard, or if you need information about the DMX
cables needed to link this product to a DMX controller, you may download the DMX Primer
document from the CHAUVET® web site: www.chauvetpro.com.

DMX Modes

The Q-Wash 560Z-LED uses the standard DMX data connection for its Basic and
Advanced DMX modes. You will find information about these DMX modes in the Operation
chapter (configuration details), and the DMX Values section (individual channel values).
Master/Slave
The Master/Slave mode allows a Q-Wash 560Z-LED product to control one or more
products of the same model without a DMX controller. The controlling product becomes the
Connectivity
"master" when running the Auto1, Auto2, or Custom programs. You must configure the
controlled (slave) products to operate in "SLAVE" mode from their respective control
panels. During the Master/Slave operation, the slave products will operate in unison with
the master product.
DO NOT connect a DMX controller to the products operating in Master/Slave mode.
Otherwise, the signals from the DMX controller may interfere with the signals from
the master product.
The Operation chapter of this manual provides detailed instructions on how to
configure the Master and Slave units.
Q-Wash 560Z-LED User Manual Rev. 05 -7-