Denso GT10Q-SU User Manual page 19

Windows 2000
(1) Switch your computer on to run Windows 2000. Log on as an Administrator.
(2) Double-click the driver icon to extract it.
(8) To make sure that the USB-COM device driver has been
successfully installed, open the Windows' Device Manager.
If DENSO WAVE USB-COM Port is added to the
sub-tree of Ports (COM & LPT) as shown at left, the
scanner is connected normally.
If the device is not added or it is marked with
remove this driver with the uninstaller, reboot your
computer, and perform the above connection process again.
(3) Connect the scanner's USB interface cable to the computer
or USB hub, and the "Found New Hardware" appears.
(4) The Found New Hardware Wizard starts.
Click Next to proceed.
(5) Select Search for a suitable driver for my device
(recommended), then click Next.
10
or ,