Operating Instructions - AirSep Focus Portable Patient Manual

[Read the Important Safety Rules section before operating this equipment]

Operating Instructions

1. Locate and position Focus so that the air inlet and outlet are not obstructed.
2. Power the unit f rom (a) the battery ; (b) DC outlet (i. e. automobile or motor boat); or (c) an AC outlet (i.e. norm
household electric). (Refer to the Power Supplies section of this Patient Manual.
(Refer to Connecting to Focus's Power Inlet
3. Securely connect your cannula to the oxygen outlet, as shown in Figure 18.
Use no oil, grease, or petroleum-based or other flammable products on the oxygen carrying accessories or the Focus
unit. Oxygen accelerates the combustion of flammable substances.
4. Lift the control panel tab on the unit's power inlet and connect the selected power source. (i.e., battery, AC or DC power
supply, or optional AirBelt)
5. Turn the Focus unit on by pressing the power switch to the on position (
illuminate, alternating between green and red, mom entarily. Also, each time you turn on Focus , a brief alarm sounds.
This indicates that Focus is powered for use.
When Focus senses inhalation, oxygen is supplied to you through your cannula.
The time required to reach maximum oxygen concentration after turning on the Focus unit is approximately two minutes.
6. To turn Focus off, press the power switch to the off position (
MN170-1 rev A 03/11
section for specific instructions on the connection of power sources.)
0
).
l). The LEDs on the contro l panel will
al
18