AirSep Focus Portable Patient Manual page 18

Charging the Optional AirBelt
To charge the AirBelt battery for extended use:
1) Release safety cap from end of the AirBelt cord.
2) Connect the AC/DC power supply (included with AirBelt Accessory kit) to the end of AirBelt's power cord, as shown
in Figure 17.
3) Connect the AirBelt power supply to an AC electrical outlet to recharge.
Replace safety cap on AirBelt cord when not in use.
Do not attempt to charge the optional AirBelt with the Focus power supply or the AirBelt can be damaged.
Use only the AirBelt power supply provided to charge AirBelt.
 The Focus AirBelt will completely recharge from its fully depleted state in approximately 3 ½ hours.
 While charging a fully discharged battery, the LED will continue to blink until 25% capacity is reached. The LED will then turn solid.
 Each of the four LEDs, 25% -100%, will blink as stated above, then turn solid when
 When all LEDs illuminate solid, the battery is fully charged and the LEDs will remain solid for a period of time, then all four LEDs will
turn off.
MN170-1 rev A 03/11
Figure 17: AirBelt Battery Charging set-up
AirBelt
Connecting the AirBelt cord to the power supply cord
AC/DC Power Supply
the battery reaches it's capacity
.
14