Initial Set-Up; Setting Water Hardness; Setting The Coffee Temperature; Machines Automatic Shut-Off Feature - Krups Espresseria Automatic Instructions Manual

FALCON PICTO anglais USA.qxp
Before you first use your machine, it will ask you to set several parameters. Please note, if you disconnect the machine from
the power source, you will need to complete parts of this process again.
Connect the machine to
the mains power supply
but do not turn it on.
Machines are
pre-set in the factory
for hardness level 3.
Machines are
pre-set in the factory
to 2, average
temperature.
Press the steam key to
switch to coffee
temperature setting =>
Machines are
pre-set in the factory
to shut-off after 1 hour
of non-use.
You can program the
automatic shut-off
of your machine.
Press the steam key to
switch to automatic
cut-off setting =>
At each stage you can store desired settings by pressing the
The settings will remain memorised even if there is a power failure.
You can change these settings at anytime by repeating the same operations.
25/02/08

INITIAL SET-UP

Lift the cup tray by
The digital display for
pressing on the back to
parameter setting is
make it tilt.
under the servicing flap.

SETTING WATER HARDNESS

The 'water tank' light
will come on.

SETTING THE COFFEE TEMPERATURE

The 'calc' light will
come on.

MACHINES AUTOMATIC SHUT-OFF FEATURE

The 'clean' light will
come on.
18:36 Page 8
Press the 'Service' and
keys at the same
time.
Press the key as
many times as are needed
to select the hardness
level for the water used.
Press the key as
many times as are
needed to select the
desired coffee temperature.
Press the key as
many times as are
needed to select the
desired duration.
key or continue the procedure.
8
Look down vertically to
the bottom of the win-
dow.
0 = very soft
1 = soft
2 = moderately hard
3 = hard
4 = very hard
1 2 3
1 = 1 H
2 = 2 H
3 = 3 H
4 = 4 H