Seal The Openings - GE JGBP86 Owner's Manual & Installation Instructions

3
ELECTRICAL CONNECTIONS
B. Usage Situations where Appliance Power Cord will
be Disconnected Frequently.
Do not use an adapter plug in these situations because
disconnecting of the power cord places undue strain on
the adapter and leads to eventual failure of the adapter
ground terminal. The customer should have the two-
prong wall receptacle replaced with a three-prong
(grounding) receptacle by a qualified electrician
before using the appliance.
The installation of appliances designed for mobile
home installation must conform with the Manufactured
Home Construction and Safety Standard, Title 24 CFR,
Part 3280 (formerly the Federal Standard for Mobile
Home Construction and Safety, Title 24, HUD, Part
280) or, when such standard is not applicable, the
Standard for Manufactured Home Installations, latest
edition (Manufactured Home Sites, Communities and
Set-Ups), ANSI A225.1, latest edition, or with local
codes. In Canada, mobile home installation must be
in accordance with the current CAN/CSA Z240/MH
Mobile Home Installation Code.
Electric Disconnect
s Locate disconnect plug on the range back.
s Pinch sides of connector and pull out of range back.
4

SEAL THE OPENINGS

Seal any openings in the wall behind the range and in the
floor under the range when hookups are completed.
Installation Instructions
(CONT.)
50
ASSEMBLE SURFACE BURNERS
5
A
Assemble the side burners as shown.
Side
Grate
Burner base
(not removable
on side burners)
B
Assemble the center burner. Make sure that the
center griddle sits square and level between the
side grates.
CAUTION:
Do not operate the burner
without all burner parts in place.
Oval head and cap
assembly
Medium burner
head and cap
Front of range
Large burner
head and cap
Place the burner caps on the cooktop. Make sure
that the caps are placed in the correct locations.
There is one oval (center) head and cap assembly,
one small cap, one medium cap, one large cap, and
one extra large cap.
Electrode
Make sure the slot in the burner head is
positioned over the electrode.
Burner cap
Electrode
Center
Griddle
Burner head
and cap
assembly
Electrode
Small burner
head and cap
Extra large burner
head and cap
Slot