Regular Site Schedule; Holiday/Exception Schedule; Change Site Information; Change Self Monitoring - 3M XT-1 Operating Instructions Manual

Change Site Information

Change Self Monitoring

3M™ Wireless Communication System, Model XT-1: Operating Instructions
Note:
All timekeeping is done using a 24 hour clock (e.g., 6:00 p.m. appears as
18:00).

Regular Site Schedule

The regular site schedule is the opening and closing times for each day of the
week and the times assigned as "Day" and "Night," which determine when the
day and night volume settings change.
Perform the following procedure to set the regular site schedule:
1. Enter the base station configuration mode, see page 9.
2. Navigate to
3. Change the value for each day of the week and each of the four defined
Open
fields (
(Press

Holiday/Exception Schedule

The holiday/exception schedule can be used to identify up to 12 days in the year
on which the store schedule is different than it would have been otherwise. The
holiday/exception schedule should be updated at least once a year to ensure it
conforms to the current year's calendar.
Perform the following procedure to set the holiday/exception schedule:
1. Enter the base station configuration mode, see page 9.
2. Navigate to
Schedule
3. For each day that needs a non-typical schedule, enter the three-letter
month and two digit date under Date, then change the open and close
times on the line to the right of the date.
(Press
Site information is useful for warranty registration and to support service calls.
This information is most useful when the system has an internet connection.
Tech Services can use it to identify and contact the store when it receives a
service request. All information is entered free-format using the numeric
keypad. To type upper case letters, use the Shift key.
Perform the following procedure to change the site information:
1. Enter the base station configuration mode, see page 9.
2. Navigate to
3. For each field that needs to be modified, enter the appropriate data.
(Press
Self-monitoring is a function available for all systems where the base station is
continuously connected to a store Ethernet connection. The base station keeps
track of all of the headsets in the system, looking for periods of extended non-
use that may indicate a headset problem that needs attention.
Perform the following procedure to enable and configure self monitoring:
1. Enter the configuration mode, see page 9.
12 Self Monitoring
2. Select
10 Site Scheduling
Day Night Close
, , , and
, , , and to scroll up and down the list).
10 Site Scheduling
.
, , , and to scroll through the fields.)
11 Site Information
, , , and to scroll through the fields.)
.
Configuration
Regular Site Schedule
>
).
Holiday/Exception
.>
.
Rev 1.0 © 3M 2007 November
Page 21 of 48
.