Pir Delay - Securesight VL1 Manual

LED
This menu controls the operation of the LED indicator on the front of the
VL1. There are three choices Flash, PIR, Off.
Select Flash mode and the LED will flash at approximately 5 seconds
intervals and come on continuously during recording.
Select PIR mode and the LED will only come on continuously during
recording (After the PIR motion sensor has been triggered).
Select OFF mode and the LED will be off during normal operation.

PIR delay

This option allows you to set a delay which causes the VL1 to wait after
being triggered before it will respond to a trigger again. The delay
options are 0 seconds (no delay) through to 120 seconds (3 minutes).
This can be useful to minimise recordings.
Page No. 35
Regardless of this setting, the LED will flash
rapidly whilst your VL1 is arming or if movement
is detected but no SD card is fitted.
©Securesight 2009 E&OE Issue 1.0