Radio (Am/Fm) Operation - Clarion CMS2 Owner's Manual

Radio (AM/FM) Operation

Select Tuner As Playing Source
Press the [SRC] Source button to select the AM/FM mode.
World Tuner
This unit is initially set to USA frequency intervals of
10 kHz for AM and 200 kHz for FM. When using it outside
the USA, the frequency reception range can be switched
to the intervals below.
U.S. A
standard
Frequency
10KHz
spacing
AM
Frequency 530-1710
range KHz
Frequency
200KHz
spacing
FM
Frequency 87.9-107.9
range MHz
[ ] Tuning Up / [
Buttons
1. Press the [ ] / [ ] button change intervals step by
step.
2. Press and hold the [ ] / [ ] button to seek to the next
strongest station.
Recalling a Preset Station
A total of 10 preset positions (P1~P10) exists to store
individual radio stations in memory.
Press [ ] / [ ] button to select the desired preset station.
Presets
1. Select the desired station with seek tuning or manual
tuning.
2. Press and hold the [ /
3. Press the [ / ] button to select a preset number.
4. Press the [ ] button to store current station into
preset memory.
8
CMS2
Europe Aisa Australia
standard standard standard
9KHz 9KHz 9KHz
531-1602 531-1620 531-1620
KHz KHz KHz
50KHz 50KHz 100KHz
87.5-108 87.5-108 87.5-108
MHz MHz MHz
] Tuning Down
] button
[OP] Options Button
During listening to the radio (AM/FM), press the [OP]
Options Button to access the radio options.
Radio Mode Options:
Auto Store LO/DX
Auto Store
Only stations with sufficient signal strength will be
detected and stored in the memory.
1. Press the [OP] Options button.
2. Press the [ / ] button until "Auto Store" is displayed.
3. Press the [ ] button to start automatically select
nine strong stations and store them into nine presets.
The new stations replace any stations already stored
in the band.
LO/DX
When LOCAL seeking is ON, only those radio stations
with strong radio signal could be received.
1. Press the [OP] Options button.
2. Press the [ / ] button until "LO/DX" is displayed.
3. Press the [ / ] button to select local (LO) or distant
(DX) mode.
Note: Press [OP] Option button to exit.
Area Set
This option allows you to select the appropriate frequency
spacing for your area.
1. Press the [ADJ] Adjust button.
2. Press the [ / ] button until "Area U.S.A" is displayed.
3. Press the [ / ] scroll through the Area options:
"Area U.S.A", "Area Europe", "Area Asia", "Area
AUST (Australia)"
Note: Default is USA frequency. Once the region is
changed, all the stations in the preset memory will be
erased.